MK8 Console Panel

Applies to airlift controller mount and gauge pods

Place panel into console to familiarize yourself with its position.
Remove panel.
Run your wiring as needed. You can remove the rubber tray on the bottom of the console pocket, this will expose some holes in the console that you can use to fish thru your wiring.

2. Wipe down the two sides, and bottom center portion of the console with the included alcohol swab. Allow the moisture to flash off before proceeding.

3. Remove the three adhesive tab covers on the panel. A knife is helpful to begin separating them.

4. Place the console back into position. Press down on the center front edge of the panel for at least one minute to help the adhesive bond.

5. Repeat for the two sides.

6. Finished!